Step One
Firstly, wrap thread around hook several times to lay a base. This helps to give a little grip for the rest of the materials that you are going to tie on. Hold the end of the thread in one hand and start wrapping the thread around and over itself to hold the loose end in place. Wrap down the shank a little way and back up towards the eye. Snip off the loose thread. |
Step Two
Take a small bunch of crystal flash approx 8-10cm long. On this fly I wanted the red on the underneath of the fly to represent the gills or bleeding gills of a baitfish. Roughly measure where halfway is on the length of the bunch of crystal flash and lay on the hook. Wrap thread a couple of turns (not too tight) and position the cyrstal flash to sit on the underside of the hook. Wrap a few more turns with the thread to (tighter this time) to keep in place. |
Step Seven
Cut a wing shape (see here) and place on top of the fly and wrap several more turns of thread to form a head. Tie off and coat head with some fly cement. Some people use nail polish for this job. |